Puppy Winthorpe
Registered User
Join date: 21 Jul 2006
Posts: 3
|
11-21-2006 09:22
How do you alter the nyterave poseball script so you sit in the same place as the ball, and not slightly above it? thx
|
Persephone Milk
Very Persenickety!
Join date: 7 Oct 2004
Posts: 870
|
11-21-2006 10:34
Puppy, I do not have the script in front of me. But what you are looking for is a vector value expressed as three numberic values, separated by commas, and living inside of angle brackets (for example, <X,Y,Z>  . This vector value will be applied as an offset to the SitTarget of the pose ball. You want to adjust the Z value, up or down, to change the position of your avie. Positive values move you higher, negative values move you down. Note that you will have to get up and re-sit, each time you change this value or you won't see the difference. Hope this helps 
_____________________
~ Persephone Milk ~
Please visit my stores on Persenickety Isle Musical Alchemy - Pianos, harps and other musical intruments. Persenickety! - Ladies Eyewear, Jewelry and Clothing Fashions
|
Puppy Winthorpe
Registered User
Join date: 21 Jul 2006
Posts: 3
|
11-21-2006 12:14
Yes but to what value, if you know? thx
|
Joannah Cramer
Registered User
Join date: 12 Apr 2006
Posts: 1,539
|
11-22-2006 18:41
From: Puppy Winthorpe Yes but to what value, if you know? If you want the ball to be exactly where middle of AV is, use some very small value like: <0.0, 0.0, 0.01> ... this puts the ball 1 cm below the centre of AV. Can't use all 0's there unfortunately, because this causes script to remove information about how to place the AV altogether :/
|