|
Nathan Stewart
Registered User
Join date: 2 Feb 2005
Posts: 1,039
|
09-24-2005 13:59
I know many builders have been dealing with this for a while, and well i went to check this old bug out today to see if it got fixed, and its the spiral staircase but Which is basically you have trouble setting up a cycliner, i think it was anticlockwise spiral, using twist begin and end cut Ie twist begin and end B -120 and E 120 and the other direction is reversed 120 and -120 in both you need to Set Cut begin and End with B at 0.98 In previous tests one of the above would result in the spiral looking ok, but it acted like you couldnt enter it, give it a try because i can no longer break it, if so bug it  |
|
Jillian Callahan
Rotary-winged Neko Girl
Join date: 24 Jun 2004
Posts: 3,766
|
09-24-2005 15:34
At the moment, there are several ways to break the bounding box on a cylinder.
I'll hop in the test grid this evening to repeat your experiment and bug it if it breaks the box.
|