Texture repeat per face, inside and out

A simple hollowed square, with a texture applied does not show same both inside and out. If I have repeat of 10 for outside, inside will be much less. Is there a way to make both sides the same?

Thank You.

No, the mapping is different. The inside of a cube is counted as just one face, so it handles repeats and offsets differently. You'll need to use a much higher repeat on the inside to make it look the same as the outside.

and as far as i know it is not interior = exterior x 4

its 1x tall 4x wide on a cube

Actually, to be precise, the interior texture has a horizontal repeat of 4 times the hollow % value. So if you have a cube that is 95% hollow, a repeat of 1x vertical and 3.8 horizontal will put a 1x repeat horizontally on all 4 interior faces. (4*0.95=3.

If the hollow value was 75%, you would need a horizontal repeat of 3 to get all 4 interior faces to appear to be a 1x repeat.

In edit mode, click the "select texture" radio button, then click on the interior surface of the hollowed cube. Now you can go to the texture tab and change the horizontal repeat value for just the interior surface.

Incidentally, because it is a single inside face, there is no way to apply different textures to each of the 4 interior faces. You would have to instead make a single texture with the four desired textures 'stitched together' side by side, and apply that to the interior.

Thank you, it makes since now. I had done the texture bit on inside surface before and noticed it was already at 10 per. But I did not think to change it. So I did not think I had any options. But after reading all these posts, yall, explained what was occuring. Thank you all.